# Invocation command line: # /cpu2006/bin/runspec -c cpu2006.1.0.ic91.linux64.intel64.Jan082007 -T all --input ref -n 3 --rate 8 -o all fp # output_root was not used for this run ############################################################################ ######################################################## # SPEC CPU2006 Intel Linux x64 (64-bit) config file # # Jan 8 2007 Intel Compiler 9.1 for Linux x64 Intel64 # ######################################################## action = validate tune = base or peak ext = cpu2006.1.0.ic91.linux64.intel64.Jan082007 PATHSEP = / flagsurl000 = http://www.spec.org/cpu2006/flags/CPU2006_flags.20090715.18.xml check_md5 = 1 mean_anyway = 1 reportable = 1 #include: SUT.inc # ----- Begin inclusion of 'SUT.inc' ############################################################################ # File to be included into config file for SPEC CPU2006 # This include file specifies the "System Under Test" (Hardware, # OS, BIOS, etc.) # Any information about the binaries is elsewhere. # To avoid conflicts in the numbering of the notes, # please use only 900 and higher numbers. ####################################################################### # System information # # If some remarks about BIOS or Firmware are needed, place them here. # ####################################################################### default=default=default=default: notes_os_000= 'ulimit -s unlimited' was used to set the stacksize to unlimited prior to run notes_000= notes_005 = The PRIMERGY RX300 S3 and the PRIMERGY TX300 S3 are electronically equivalent. notes_010 = notes_015= The system bus runs at 1333 MHz notes_020= notes_025= BIOS configuration: notes_030= Hardware Prefetch = Disable, Adjacent Sector Prefetch = Disable notes_035= ################################### # About Fujitsu Siemens Computers # ################################### default=default=default=default: notes_040= notes_045= For information about Fujitsu Siemens Computers in your country please see: notes_050= http://www.fujitsu-siemens.com/countries ##################################### # Description Hardware and Software # ##################################### default=default=default=default: hw_vendor = Fujitsu Siemens Computers hw_model000 = PRIMERGY RX300 S3, Intel Xeon processor X5355, hw_model001 = 2.66 GHz hw_cpu_name = Intel Xeon X5355 hw_cpu_char = X5355 hw_cpu_mhz = 2666 hw_fpu = Integrated # hw_nchips = 2 hw_ncores = 8 hw_ncoresperchip = 4 hw_nthreadspercore = 1 # hw_ncpuorder = 1,2 chips hw_pcache = 32 KB I + 32 KB D on chip per core hw_scache = 8 MB I+D on chip per chip, 4 MB shared / 2 cores hw_tcache = None hw_ocache = None hw_memory000 = 16 GB (8x2 GB DDR2 PC2-5300F, 2 rank, CAS 5-5-5, hw_memory001 = with ECC) hw_disk = SAS (73GB 15400 rpm) hw_other = None sw_file = ReiserFS sw_state = Default license_num = 22 test_sponsor = Fujitsu Siemens Computers tester = Fujitsu Siemens Computers test_date = Feb-2007 hw_avail = Jan-2007 prepared_by = Fujitsu Siemens Computers config = cpu2006.1.0.ic91.linux64.intel64.Jan082006.cfg # ---- End inclusion of '/cpu2006/config/SUT.inc' default=default=default=default: CC = icc CXX = icpc F77 = ifort FC = ifort OBJ = .o ########################### # portability & libraries # ########################### default: PORTABILITY = -DSPEC_CPU_LP64 400.perlbench=default: CPORTABILITY = -DSPEC_CPU_LINUX_X64 403.gcc=default: EXTRA_CFLAGS = -Dalloca=_alloca 462.libquantum=default: CPORTABILITY = -DSPEC_CPU_LINUX 483.xalancbmk=default: CXXPORTABILITY = -DSPEC_CPU_LINUX 435.gromacs=default: LDPORTABILITY = -nofor_main 436.cactusADM=default: LDPORTABILITY = -nofor_main 454.calculix=default: LDPORTABILITY = -nofor_main 481.wrf=default: CPORTABILITY = -DSPEC_CPU_CASE_FLAG -DSPEC_CPU_LINUX ######################### # Baseline Tuning Flags # ######################### default=base=default=default: OPTIMIZE= -fast ##################### # Peak Tuning Flags # ##################### default=peak=default=default: OPTIMIZE= -fast PASS1_CFLAGS = -prof_gen PASS2_CFLAGS = -prof_use PASS1_FFLAGS = -prof_gen PASS2_FFLAGS = -prof_use PASS1_CXXFLAGS = -prof_gen PASS2_CXXFLAGS = -prof_use PASS1_LDFLAGS = -prof_gen PASS2_LDFLAGS = -prof_use 401.bzip2=peak=default=default: basepeak=yes 462.libquantum=peak=default=default: basepeak=yes 483.xalancbmk=peak=default=default: basepeak=yes 416.gamess=peak=default=default: basepeak=yes 433.milc=peak=default=default: basepeak=yes 434.zeusmp=peak=default=default: basepeak=yes 436.cactusADM=peak=default=default: basepeak=yes 437.leslie3d=peak=default=default: basepeak=yes 444.namd=peak=default=default: basepeak=yes 450.soplex=peak=default=default: basepeak=yes 459.GemsFDTD=peak=default=default: basepeak=yes 470.lbm=peak=default=default: basepeak=yes 481.wrf=peak=default=default: basepeak=yes 482.sphinx3=peak=default=default: basepeak=yes ######################### # Used Compilers and OS # ######################### fp=default=default=default: sw_compiler000 = Intel C++ Compiler for Linux64 EM64T version 9.1 sw_compiler001 = Build 20061101, Package-ID l_cc_p_9.1.045 sw_compiler002 = Intel Fortran Compiler for Linux64 EM64T version sw_compiler003 = 9.1 sw_compiler004 = Build 20061101 Package ID: l_fc_p_9.1.040 default=default=default=default: sw_other = None sw_os000 = 64-Bit SUSE LINUX Enterprise Server 10, Kernel sw_os001 = 2.6.16.21-0.8-smp on an x86_64 sw_avail = Nov-2006 sw_auto_parallel = No sw_base_ptrsize = 64-bit sw_peak_ptrsize = 64-bit